Pavarini Insurance is a licensed insurance producer and is compensated when a bond is placed through this site. This page is general information, not legal, tax or fiduciary advice, and it is not a substitute for reading your plan document or contract or for advice from your own counsel. Figures shown are current as of the date on this page.
There is no national public official bond amount, no state-wide figure in most states, and no table a surety can look it up in. The amount is set by whatever created the requirement, and that is the first thing to establish, because a bond written for the wrong amount does not satisfy the statute even if it is otherwise perfect.
Three ways the amount gets set#
A flat figure in the statute. Some offices carry a fixed amount written into the law. Louisiana's assessor bond is an example: $3,000 for each representative the parish has in the legislature, up to $10,000, with Orleans Parish fixed at $5,000. When the figure is in the statute, nobody has discretion to change it and the clerk should be able to point to the section.
A formula. Offices that handle large and variable sums are often bonded by formula. Louisiana's sheriff, as ex officio tax collector, gives bond for $1,000 more than the state and parish taxes on the last assessment roll, capped at $20,000, with East Baton Rouge Parish fixed separately at $300,000. Other states tie treasurer and collector bonds to a percentage of the funds handled in the prior year. A formula means the number can change from one term to the next, so do not copy last term's bond.
The governing body. For many municipal and district offices, and for county offices in some states, the statute says the board or council shall fix the amount, sometimes within a range and sometimes without one. Colorado's county treasurer bond works this way: the board of county commissioners sets it by written resolution before the treasurer is sworn in. Where the governing body sets the amount, the resolution is the requirement. If there is no current resolution, there is no number, and the surety cannot write the bond until there is.
Why the first number you hear is often wrong#
Two reasons, and they are both about using old information.
First, the predecessor's bond. People naturally assume the new bond matches the old one. But a formula may have moved, a board may have passed a new resolution, and a statute may have been amended. The outgoing officer's bond tells you what the requirement was, not what it is.
Second, generic bond websites. Many list a single amount for a state's public official bond, usually copied from one county's form years ago. Those pages are not the statute. The clerk who will accept your oath has the current figure or can get it from the entity's attorney, and that is the only source worth using.
Minimums, maximums and buying more#
Where a statute states a minimum, the governing body can usually require more. Where it states a maximum, the bond cannot exceed it. Where the statute is silent and the board sets the figure, the board can set whatever it believes protects the public, and many boards revisit the number when the entity's budget grows.
An officer may also carry more than the required amount. It costs a little more and does not change the compliance analysis. For a treasurer or collector handling several times the required bond, the question of whether the statutory minimum is enough protection is a fair one to raise with the board, though it is their decision and not yours.
The one question to ask#
Ask the clerk: what is the amount of the bond for this office, and what sets it? If the answer is a statute, get the section. If it is a resolution, get the date and a copy. If the answer is a shrug, ask for the entity's attorney, because a bond with the wrong amount is not a bond that satisfies the requirement, and the surety will write whatever number you give it.
Common questions
How much is a public official bond?
It depends entirely on the office and the state. Amounts are set by a flat figure in a statute, by a formula tied to funds handled, or by the governing body in a resolution. Ask the clerk who will take your oath for the current amount and what sets it.
Can I just use the same amount as the person before me?
Not without checking. Formulas change with each assessment roll or budget, boards pass new resolutions, and statutes get amended. The predecessor's bond shows the old requirement, not necessarily the current one.
Who decides the bond amount for a city treasurer or clerk?
Usually the city council or village board, by resolution, where the statute gives it that authority. Some statutes also let the governing body waive the bond entirely. The clerk of the governing body will have the resolution.
What if the board has not set an amount?
Then there is no number for the surety to write. Ask for the item to be placed on the next agenda. This is one reason to start the process the week after the election rather than the week before the oath.
Can the bond be for more than the required amount?
Yes. A bond above the statutory or resolved amount still satisfies the requirement and costs only a little more. Whether a higher amount is appropriate for an office handling large sums is a decision for the governing body.

